Need straight forward answer about Touch screen mode

Discussion in 'Modding and Customization' started by niceguy60, Jun 16, 2009.

  1. niceguy60

    niceguy60

    Joined:
    Jun 16, 2009
    Messages:
    5
    Likes Received:
    0
    Need a answer from someone who has actually installed a solderless Touch screen in the below described configuration. It concerns the touch screen hub, will my web camera along with the touch screen function after they been attached to the hub powered by the 3.3 volts connector or will my camera just die or random disconnect after being installed through the hub. I also need to hook up a bluetooth dongle to the hub, can it handle this. Can the Touch screen hub use 5 volts or is 3.3 the only option

    Should I leave the web cam connector alone and would it be possible to use the mini PCIe connector on the back of the mobo. Basically I need a configuration that just works. Lastly is cn11 alive or just dead because after searching these forums I am getting different opinions.
     
    niceguy60, Jun 16, 2009
    #1
  2. niceguy60

    jerryt

    Joined:
    Jan 5, 2009
    Messages:
    839
    Likes Received:
    0
    Depends, on the kit you have. some don't like 5 volt input.

    mPCIe connector and CN11 both are working sources for usb.
     
    jerryt, Jun 16, 2009
    #2
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Need a quick answer I hope!

  2. The way forward ?

  3. Swipe touchpad to go forward/back?

  4. Transmission - port forward

  5. New here, need an answer.

  6. Need a quick answer about external power if possible...

  7. How to boot straight to VGA out?

  8. Asus X55C boots straight into BIOS, HDD and optical drives not detected

Loading...