HP Notebook project [Soldering/electrician question]

Discussion in 'Modding and Customization' started by zeromaveric, Jan 24, 2019.

  1. zeromaveric

    zeromaveric

    Joined:
    Jan 24, 2019
    Messages:
    1
    Likes Received:
    0
    I have an idea in mind i'd like to do with my laptop. I've seen a few desktop videos of people adding LED strips wired to the motherboard, and my project is similar.

    Basically, i want to get a couple of IR emitter diodes wired to the board, except i don't have a clue on voltage, amperage, etc., let alone where to begin on the board itself. The goal is to make an in-house sensor bar for Wii emulation. (If it's not allowed to mention such things, i apologize)

    I've looked for solutions online, which say to get a usb sensor bar or the old candle trick. That may be good for desktops, but for a laptop, i want something more built in, and i don't have to carry extra hardware to set up

    Btw, my laptop is an HP Pavillion 15- au020wm
     
    zeromaveric, Jan 24, 2019
    #1
    1. Advertisements

Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.